UBX-22006906 -
R03
Page 22 of 44
C1-Public
The powering options are controlled with jumper J2, as shown in
Figure 19: Jumper J2 powering options
J2 jumper settings are described in
Jumper position
Pins
Power setting
P
1
–
2
Power over Ethernet or barrel jack. When the barrel jack is present and
connected to a voltage source, the device automatically gives priority to
that, even if a PoE switch is also connected to the ethernet plug.
N
3
–
4
USB connector J15 (USB interface of the ANT-B10).
F
5
–
6
USB connector J13 (USB connector of the FTDI chip for UART connection
to the processors on EVB-ANT-1 or the antenna board).
Table 3 Jumper J2 settings
4.8
Mechanical specifications
EVB-ANT-1 Dimensions: 126.09 mm x 126.09 mm.
EVB-ANT-1 has four mounting holes that match the four corner holes on the ANT-Bxx antenna board
for screw mounting.
Figure 20: EVB-ANT-1 mechanical dimensions
Summary of Contents for XPLR-AOA-3
