u-blox XPLR-AOA-3, User Manual

Page: 21 / 44

UBX-22006906 - R03 Page 21 of 44
C1-Public
From the configuration interface, you can:
• Configure network settings for Wi-Fi and ethernet. The default IP address of EVB-ANT-1 is
192.168.1.102.
• Send UDP packets containing angle events generated by the anchor. It is often convenient to
broadcast the address of the network, as shown in
Figure 18 .
• Configure the active NINA-B411 module as either the NINA-B411 mounted on the ANT-B10 board
or the onboard NINA-B411 (connected to the custom antenna header).
Figure 18: Configuring the active NINA-B411 and destination for angle events
After updating the configuration, select Submit to send it to the MCU and save it to flash. Select Read
to retrieve current configuration.
4.6 Boot options
Use the SW3 DIP switches to set the board in regular boot mode or serial downloader mode, ss shown
in
Table 2 .
Switch/Boot option Switch 1 Switch 2 Switch 3 Switch 4
Boot from flash Off Off On Off
Serial Downloader Off Off Off On
Table 2 Boot options using SW3 switch
4.7 Powering options
EVB-ANT-1 is powered by either:
•
Power over Ethernet
• An auxiliary jack (DC 9-57V)
• USB type C (2 connectors available on the board)