u-blox LARA-R203, System Integration Manual

Page: 52 / 157

LARA-R2 series - System Integration Manual
UBX-16010573 - R12 System description
Page 52 of 157
1.9.3 HSIC interface
The HSIC interface is not supported by the “02” and “62” product versions except for diagnostic purposes.
1.9.3.1 HSIC features
LARA-R2 series modules include a USB High-Speed Inter-Chip compliant interface with a maximum 480 Mb/s data
rate according to the
High-Speed Inter-Chip USB Electrical Specification Version 1.0 [10] and the USB Specification
Revision 2.0 [9]. The module itself acts as a device and can be connected to any compatible host.
The HSIC interface provides:

AT command mode 16

Data mode and Online command mode 16

FW upgrades by means of the FOAT feature (see 1.14.14 and the Firmware update application note [23])

FW upgrades by means of the u-blox EasyFlash tool (see the Firmware update application note [23])

Trace log capture (diagnostic purpose)
The HSIC interface consists of a bi-directional DDR data line (
HSIC_DATA ) for transmitting and receiving data
synchronously with the bi-directional strobe line ( HSIC_STRB ).
The modules also include the
HOST_SELECT
pin to select the module / host application processor configuration:
the pin is available to select, enable, connect, disconnect and subsequently re-connect the HSIC interface.
The USB interface is controlled and operated with:

AT commands according to 3GPP TS 27.007 [6], 3GPP TS 27.005 [7]

u-blox AT commands (for the complete list and syntax, see the u-blox AT Commands Manual [2])
16
See the u-blox AT Commands Manual [2] for the definition of the command mode, data mode, and online command mode.