u-blox C030-R412M, User Manual

Page: 22 / 27

C030-R412M - User Guide
UBX-19010121 - R01 Getting started Page 22 of 27
3 Getting started
3.1 C030-R412M board setup
1. Connect the Main cellular antenna to the cellular main antenna SMA female connector (ANT1).
2. Connect the GNSS antenna to the GNSS antenna SMA female.
3. Configure the C030-R412M as described in section 2.2 .
4. Power up the C030-R412M as described in section 2.8 .
3.2 Development PC USB driver configuration
Although the USB drivers can be loaded by the development PC operating system automatically, it is
recommended to follow the guidelines mentioned below:
 The debug USB port STLink/V2-1 interface needs a driver. These drivers are available at:
http://www.st.com/content/st_com/en/products/embedded-software/development-tool-
software/stsw-link009.html
.
 Similarly, the cellular modem USB sniffer USB port interface needs a driver, which is available at:
http://www.silabs.com/products/interface/usb-bridges/classic-usb-bridges/device.cp2105
3.3 Getting started with Mbed
Up-to-date information on how to operate the C030-R412M starter kit within the Mbed development
environment is available at:
 https://developer.mbed.org/platforms/ublox-C030-R412M/
(Link forwards automatically to the site https://os.mbed.com/platforms/ublox-C030-R410M/ )