10
5.5 ASCII commands to configure RD05
After completing the above steps to RD05 on electricity, then send the FFF make
machines to enter configuration mode, according to the instruction table 5.1 set up
machine, set up after the completion of the send #DQ make machine to exit the
configuration mode, when the reader receives the TAG information, RS232 and USB
port can output the corresponding information
Table 5.1 TZ-RD05 unify commands
NO.
Instruction
Format
Note
FFF
Enter configure mode
FFF
the instruction can work, after
entering
the
configuration
mode; And then have to send
command in 10s after entering
the
configuration
mode,
otherwise it will exit the
configuration mode
00
Set again the stress time
*00,X#
X: [0, 3600], unit 1S, 1 is
