Tzone TZ-AVL201, User Manual

Page: 15 / 23

TZ-AVL201 User Guide
V1.0 .2
May5
2014
15
version.
11 Initialization Tracker * $$$$$$ ,990,099# It will set all parameter to factory
default value (Excluding the Password).
12 Reboot by SMS command * $$$$$$ ,991# It will reboot the AVL201 by this SMS
command.
13 Clear data flash * $$$$$$ ,500# Clear stored in the flash memory inside
the machine
14 Map Link * $$$$$$ ,100# the device will reply a sms link .after
clicking the sms link, you will get a
segment of google map for the device
location on your cell phone.
15 OutA Change switch * $$$$$$ ,116,A# A=1, active 117 command set .
A=0, Don`t active 117 command set
16 Set OutA Change * $$$$$$ ,117,A,B,C,D# A=[0,999]km/h , the thresold of speed.
B=[0,60000] ms, the interval of outA
off
C=[0,60000] ms, the interval of OutA
on
D=[0,99], the times of OutA change
If the speed is lower than, the OutA
will off B seconds, then restore C
seconds, repeat it D times.
*note
：
because of the safety, you had
better set the parameter like this:
*000000,117,60,500,3000,5#
17 According to the digital input1
state decided to time intervals
of GPRS Data * 000000 ,156,X,Y# X=0, Disable this function(Default)
X=1, Active this function.
Y=[1,60]/minutes, Input1 have not
detection to high level (engine off)
time interval,If a high voltage is
detected, the machine according to
the 018 instructions to send data
18 Reboot time * $$$$$$ ,600,X,Y# X=0,Disable this function
(Default)
X=1, Active this function.
Y= [10,9999]/ Minutes,
Reboot time interval
19 data flash switch * $$$$$$ ,601,X# X=0,Disable data flash function
X=1,enable
data flash function
(Default)