47
www.tytusgrills.com
TYTUS 4-Burner Gas Grill & 4-Burner Island Gas Grill
ANNUAL CLEANING
Use a fiber or brass cleaning brush to clean the interior grill box, cooking grills, flame tamers, and grease containers.
Never use a wire brush or metal scraper on the porcelain finished parts as it can scratch or chip the porcelain finish and
promote rusting.
1)
Turn all the control knobs to OFF.
2)
Turn the propane tank valve off.
3)
Detach the gas line from your grill or propane tank.
4)
Remove and clean the flame tamers, cooking grills, and burners.
5)
Cover each gas valve orifice with aluminum foil.
6)
the inside and bottom of the grill with a
wash with a mild soap and warm water. Rinse thoroughly
and let dry.
7)
Remove the aluminum foil and check each orifice for obstructions.
8)
Clean the
igniter with a soft bristle brush.
9)
Replace the flame tamers and the cooking grills.
10)
Reconnect the gas source, light the grill, and observe the burner flame to make sure that it is operating correctly.
FREQUENTLY ASKED QUESTIONS
What should I do if my grill won’t light?
• Turn the gas off at its source, then turn the control knobs
OFF. Wait at least five minutes for gas to clear, then retry.
• Check your gas supply and connections.
• Repeat the lighting procedure. If your grill still fails to oper
ate, turn the gas off at its source, turn the control knobs to
OFF, then check the following:
• The burner tubes may be misaligned with the orific
es. Reposition the burner tubes over the orifices.
• There may be an obstruction in the gas line orifice. Remo
ve the fuel line from the grill. Open the gas supply for
one second to clear any obstruction from the fuel line. Close off the gas supply at its source and reconnect the
fuel line to the grill.
• Check for a plugged gas valve orifice. Remove the cotter pi
n at the rear of each burner, then carefully lift each
burner up and away from the gas valve orifice. Remove the orifice from the gas valve, and gently clear any
obstruction with a fine wire. Reinstall all orifices, burners, screws, and cooking components.
If you suspect an obstruction in the gas valves or manifold, call the TYTUS Support Center at (952) 807-9690.
• Check for obstructions in
the burner tubes. See
“Burner Tubes and Burner Ports” (page 45)
for cleaning
instructions.
• Make sure that the igniter is aligned correctly with th
e burner. The gap between the spark electrode tip and spark
receiver should be approximately 3/16" wide. Adjust if necessary. With the gas supply closed and all control
knobs set to FF, press the electric igniter cap, and watch for the presence of a spark at the end of the electrode.
• Inspect the igniter junction box found behind the control panel. Connect loose electric wires to the junction box,
and then try to light the grill.
• If the grill still does not light, you may need to purge ai
r from the gas line or reset the regulator excess gas flow
device.
How do I purge air from my gas line and/or reset the regulator excess gas flow device?
See
“Purge Air from the Gas Line/Reset the Regulator” (page 31)
for instructions.
Can I convert my grill from propane to natural gas?
Yes. TYTUS offers a kit
safely convert your propane grill to natural gas. Call
TYTUS Customer Support for more information.
WARNING:
• Accumulation of grease
can cause a fire hazard.
• Barbecue sauce and salt can be corrosive and will cause rapid deterioration of grill
components unless cleaned regularly.
WARNING: Do not smoke while clearing the gas line.
Tytus-Grills_19-0238_MAN_V1_ENG.fm Page 47 Friday, August 9, 2019 10:44 AM
