9
touches the stop #4.
3
．
Relock the nut #1. Tensioning of the V belts is only necessary if belts are
slipping. Maximum tension in when the indicator is about 1/8” clearance
from the bottom.
If a V belt breaks or comes off, the whole set of belts should be replaced.
NOTE: If the V belts are over tensioned, damage will occur to the
gearbox input shaft bearings and main drive shaft bearings. If the V belts
slip, check the V belt tension. If this is correct and the belts still slip, you
should reduce the forward speed of the tractor.
CAUTION: Never tighten the nut so far that the compression spring
becomes in operative.
CHAPTER4
MAINTENANCE AND LUBRICATION INSTRUCTIONS
●
=Grease
■
=Oil
every 5 hours of work
Figure G
The gearbox is filled with EP—0 mulligan grease. Refilling is only necessary
after repair; Grease level should come to the lower side of the horizontal shaft.
PTO
MAINTENANCE
&
LUBRICATION
INSTRUCTIONS
