33
22) Voice Prompt (VOICE---MENU 22)
Functions:
enable/disable voice prompt.
Enter Menu 22
th
to set VOICE.
by manual.
24) Power-on Display setting (OPN.SET&VLT&MSG.SET---MENU 24&25&26)
Functions:
choose power-on display mode and edit power-on message
Enter Menu 24
th
to set OPN.SET. Default: OFF.
OFF: display model version
DC: battery power voltage
MSG: power-on message
Enter Menu 25
st
to check battery voltage.
Enter Menu 26
nd
to edit power-on message, also you can edit it directly by
23) End-tone elimination
Enter Menu 23
th
to switch on/off the tail elimination function
25) Display the name (DIS.NM&CH.NAME)
Functions:
switch channel name display mode ON/OFF and edit channel name under
MR/CH mode .
26) Tone coder & Tone Search Scanning & Tone calling (C-CDC& R-CDC&
T-CDC
Function 1:
CTCSS/DCS Operation
34
If the Tone scan feature does not detect a tone or code, it will continue to scan
indefinitely. When this happens, it may be that the other station is not sending any tone.
You can press
PTT
key to halt the scan at any time.
You also can press
MONI
key during Tone scanning to listen to the (muted) signal from
the other station. When you release the
MONI
key, Tone scanning will resume.
Tone Scanning works either in the VFO or MR modes.
Operation: Press + to enter the CTCSS setting, Press to confirm, then
press to enter 32nd Menu.
OFF: Disable the CTCSS/DCS.
67.0: the CTCSS number.
D023N: DCS number.
Many repeater systems require that a very-low-frequency audio tone be superimposed
on your FM carrier in order to activate the repeater. This helps prevent false activation
of the repeater by radar or spurious signals from other transmitters.
Enter Menu 29
th
/30
th
/31
th
to set TX&RX Tone coder/ RX Tone coder/ TX Tone coder.
27) Offset frequency and direction setting(S-D&OFFSET--MENU 32 & 33)
Functions:
Under VFO mode, you can set the offset frequency and direction to connect
with repeater.
Enter Menu 32nd to set offset direction.
Default:
OFF
Enter Menu 33rd to set offset frequency.
