1.7) Reliability
1.8) Environmental Conditions
1.9) Installation
1. Life Span:
Mechanism: 15,000,000 lines
Thermal head: 100 million pulses, 100 Km
Auto cutter: 1,500,000 cuts
(End of life span is defined to have reached
the end of its life when it reaches the
beginning of the Wear out Period.)
2. MTBF:
360,000 hours
(Failure is defined as Random Failure
occurring at the time of the Random Failure
Period.)
3. MCBF:
52,000,000 lines
(This is an average failure interval based on
failures relating to wear out and random
failures up to the life of 15 million lines.)
1. Temperature:
Operating: 5 to 45C (41 to 113F)
Storage: -10 to 50C (14 to 122F)
(except paper)
2. Humidity:
Operating: 10 to 90% RH
Storage: 10 to 90% RH (except for paper)
3. Acoustic noise (Operating):
When using auto cutter Approximately 50
dB (Bystander position) When not using
auto cutter: Approximately 40 dB
(Bystander position)
The PRP-080P series printer must be installed horizontally. (Vibration during
paper cutting and using a drawer should be considered. Take measures to
prevent the printer from moving. Affixing tapes are provided as an option.) An
optional hanging bracket can attach the printer to a wall. (Following the
procedures describes in the installation manual, install the wall mount and
change the location of the paper roll near-end sensor, then install the paper roll
stopper and other parts.)
NOTE:
If the printer is not used for a long time with paper installed, some part
of the printing may be light due to the deformation of the paper. If the
printer is not used for a long time with paper installed, be sure to feed
paper approximately 30 mm before printing
2. CONFIGURATION
2.1) Interface
a. RS-232 serial interface
a.1) RS-232 Specifications
a.2) Serial interface connection example
1. Data transmission:
Serial
2. Synchronization:
Asynchronous
3. Handshaking:
DTR/DSR or XON/XOFF control
4. Signal levels:
MARK = -3 to -15 V: Logic "1"/ OFF
SPACE = +3 to +15 V: Logic "0"/ ON
5. Baud rate:
4800, 9600, 19200, 38400 bps
6. Data word length:
8 bits
7. Parity Settings:
None
8. Stop bits:
1 or more
9. Connector (printer side):
Female DSUB-25 pin connector
Printer Side DB-25
POS RS-232 Connection DB9
NOTE:
NOTE:
The data word length, baud rate, and parity depend on the DIP switch
settings.
The stop bit for the printer side is fixed to 1.
Set the handshaking so that the transmit data can be received.
Transmit data to the printer after turning on the power and initializing
the printer.
-19-
-18-
