2.3 Install Pole-type Customer Display
a.
Pass the cord of the customer display
through the holes in the directions of the
arrows. Plug the cable to a free COM port
and connect the extension power cable.
b.
Press the stand of the customer display
into place.
Note
z
The rear top mount customer display is pre-installed in factory.
z
If the 9th pin of the RS-232 connector is power in, the device can be powered directly via
the COM port by jumper setting (see “POWER COM Jumper Setting” in Section 1.3 I/O
Ports and “JP10: COM1, COM2, COM4 port RI and voltage selection” in Section 6.1
Jumper Settings). Thus the extension power cable is not necessary.
10
Summary of Contents for POSpark 5700 Series
