Tysso BCP-5500 Series, User Manual

Page: 25 / 60

-23-
Connect to PC
(Rs-232 Port)
DC Jack
Host PC
1. Turn off the computer.
Cradle
2. Connect the D-type 9-pin cable connector to the proper COM port on
computer.
3. Connect the USB Power Cable to the rear DC Jack of the RS-232
connector and HOST PC.
4. Turn on the computer.
5. The LED indicator of the receiver (Recharge/Communication Cradle) lit
RED to indicate that the receiver (cradle) is functioning.
6. Install the data collector to the cradle.
The data collector is activated automatically and a beep sound indicates
that the data collector is properly installed.
7. When first connect to the computer, install the driver and Utility
Now user can initiate the Utility and perform configuration or data
transmission.
Note:

Make sure to use the correct cable that match to the proper interface.

When plugging the optional power adaptor into the electrical outlet,
make sure that the voltage applied to the power outlet is within the
specified range of the adaptor.
Improper power source voltage range will cause damage to the power
supply unit.
5.2 Driver & Utility Installation