15
5. Operation
5.1
Setting up the saw
- Set up the saw on a clean and stable foundation.
- Test the saw's steadiness.
5.2
Saw preparations (see 3.4)
5.3
Test the direction of rotation of the saw blade (see 3.5)
5.4 Changing direction of rotation (see 3.6)
5.5 Sawing (see 3.7)
5.6 Cutting guality of the saw blade
lf the saw blade looses its sharpness after langer use, you can "sharpen" it by making some cuts
in sand-lime bricks or similar material.
5.7 Cooling water
Very dirty water reduces the life of the pump and saw blade
.
- By frequent use replace the water daily and remove the saw sludge
.
- Also clean the pump's suction strainer with each water change.
5.8 Height adjustment
The saw blade height adjustment is needed for
:
- cutting through blocks with height over 270 mm in the reversing tool.
Performing the height adjustment.
- The motor is turned off
.
- Loosen the clamping lever (item 7).
- Set the saw head to the desired height.
- Tighten the clamping lever (item 7).
5.9 Changing the saw blade (see 3.3)
6. Disassembly
- Turn back the star delta switch (item 12).
- Remove the connecting cable.
- lf there is danger of freezing, take the water pump out of the water and let the water drain off
.
ATTENTION! Frozen pumps have to be thawed out before switching them on.
- Transport (see 4)
