typical TC2210GB, Instruction Book

Page: 66 / 74

8.1 2 Adjusting the thread wiper
1）Loosen the two screws (3) and shift the entire solenoid setting plate (4) up or down to adjust
so that the thread wiper (2) is 15mm in front of the needle center when the plunger (1) of the
thread wiper solenoid is driven to the full stroke.
2）Loosen the screw (5) and adjust the position of the thread wiper (2) so that the distance from
the thread wiper to the tip of the needle is approximately 2 mm and the tip of the thread wiper
(2) is approximately 3 mm from the center of the needle when the thread wiper (2) passes below the
needle during operation.
[NOTE]
Check that the thread wiper (2) does not touch the finger guard (6).
8.1 3 Presser foot installation position
Install the presser foot (1) with the screw (2)
so that the distance from the bottom of the
presser foot to the top of the needle plate is
22mm when the sewing machine is stopped and the
presser foot (1) is raised.
59