16
17
15
5
A
B
“UP”
“DOWN”
4.2 Connecting the control box (Fig.15)
Note:
4.2.1 When connecting or removing the connector, turn
off the power to ensure safety.
4.2.2 The model must match with the control box of the
motor.
4.3 Adjusting the stop position of the needle
（
Fig.16,
17
）
4.3.1 Adjusting the position of "UP"
When the pedal is depressed by foot, the machine
should stop at the position of "UP". If it excesses more
than 3mm, adjustment should be done as follows:
Remove the power plug from the machine;
Run the machine to make the it stop at the position of
"UP";
Fix the pulley belt and insert the adjusting tool into Hole
A to adjust the reflecting plate.
Operation
Table cutout
Balance wheel
Position mark
White mark
Red mark
Adjusting tool
Back
Front
mark
mark
