ALARM CALLS DETECTED AUTOMATICALLY :
An alarm call triggered automatically may be from a smoke detector or a system fault. Answer and deal
with the call as described above. The following displays may occur :
FLAT - - 23
will be displayed if a smoke alarm has detected a fire in flat 23.
SMOKE ALARM
FLAT - - 23
will be displayed if an intruder has been detected in flat 23.
INTRUDER ALARM
FLAT - - 23
will be displayed if there is an open circuit wiring fault in flat 23.
OPEN CCT FAULT
SYSTEM FAULT
will be displayed if the system mains supply has failed.
MAINS FAIL
SYSTEM FAULT
will be displayed if the system battery standby is running low.
LOW BATTERY
MAINS RESTORED
will be displayed when the mains supply is restored.
SYSTEM FAULT
will be displayed if the system telephone line has failed.
BT LINE FAILURE
BT LINE RESTORED
will be displayed when the system telephone line is restored.
SYSTEM FAULT
will be displayed on a PAGING Portable Master Unit only.
12V FUSE BLOWN
SYSTEM READY
will be displayed when a SYSTEM FAULT call is cancelled.
FAULTS EXIST
The system will operate as normal when FAULTS EXIST is displayed but you are reminded that a
problem requires attention.
It is possible to view the contents of the system fault memory by entering a special code via the
Portable Master Unit, see section 11 of this manual.
The power supply for all the Intercom Units on your scheme is monitored by the system. Should this
supply fuse blow, a PERMANENT alarm tone will be sounded at the Portable Master Unit. This call
cannot be cancelled - call your Service Engineer immediately.
(
c) Tynetec Limited 2001
FM0313e.PDF issue A Page 5
