14
PROBLEM
POSSIBLE CAUSE
SOLUTION
The light does not
work.
Not plugged in.
Plug the cooler in.
The circuit breaker tripped
or a blown fuse.
Check the breaker and/or fuses.
The light button is
“
OFF
”
.
Press
to turn the light ON.
Vibrations.
The cooler is not leveled.
Check to assure that the cooler is level.
The bottles are vibrating.
Make sure the bottles don
’
t touch each
others.
There is an object under
the cooler.
Remove the object under the cooler.
The cooler seems
to make too much
noise.
The cooler is not level.
Level the cooler.
Normal noise from the
flow of the refrigerant
The rattling noise may come from the
flow of the refrigerant, which is normal.
As each cycle ends, you may hear
gurgling sounds caused by the flow of
refrigerant in your cooler. Contraction
and expansion of the inside walls may
cause popping and crackling noises.
The door will not
close properly.
The cooler is not level.
Level the cooler.
The door was reversed
and not properly installed.
Re-install the door properly.
The gasket is dirty.
Clean the door gasket.
The shelves are out of
position.
Place the shelves properly.
Moisture build up
on interior or
exterior of the
Beverage cooler.
This is normal during high
humidity periods.
Lower the room humidity.
This is normal in high
temperature environment.
Move the cooler to a cooler place, and
avoid heat and sunlight.
Prolonged or frequent
door openings.
Open the door less often.
The door does not seal
completely.
Check door gaskets for proper seal.
Error Code:
E1-E2-E3-E4-E7-E
8
A sensor has failed.
Contact the customer service
Summary of Contents for TYBC100
Page 15: ...15...
