Tylo Prime+ 1814, User Manual, Page: 7 / 60

• The person who is holding the door will have to help fit the section into the floor and side panel.
• When the section is securely attached to the floor and side wall panel you are ready for the ceiling
section.
Note: If additional helpers are not available to hold the glass components while two people fix
the ceiling section, fix the whole front with adhesive tape.
Ceiling:
• Lift the ceiling up and place it carefully on the four (4) wall
panels as shown below.
• Note: Ensure that the electrical connections are placed
through the ceiling and are not disconnected when you put
the ceiling into position slowly.
• Tip: To make it easier to pull cables through the ceiling
slot, you can take small styropor blocks and put them in
several places between the ceiling and the wall panels so
that the ceiling stays put. When the cables have been
pulled through, remove the styropor blocks and lower the ceiling onto the wall panels.
• Fit the front glass sections into the ceiling slot.
• Using a step ladder, open the flaps in the ceiling and turn the wooden support 90º. This fixes
the ceiling securely onto the wall panels and ensures that the door panel cannot fall out.
Page 7