Minilase™ Quick Start Guide
Rev. January 2012
•
9
Step 11:
Now that the laser system is powered up, check to be
sure the laser software and the laser system are communicating
with each other. Make sure the door to your system is in the
OPEN position and locate the icon on your desktop titled
“Minilase™ Pro 2.0”. Double-click this icon to launch the
software. When the software opens, check for connectivity in
the upper right side of the screen. If the software is connected
you will see the following icon depressed.
Now that the software is open, verify that the system and the
software are communicating. Click on the Icon shown that is
located directly to the left of the connection icon.
Step 11: Check for connectivity
Click on the checkbox located next to
“Start Text” in this window.
The laser system should now “draw”
a 10mm long line inside of the laser
workstation on the T-Slot tool base.
For verification purposes, place a white
piece of paper on top of the tool base
to easily view the red aiming beam
drawing the line. Once you have verified
this is present, you can close the “Laser
test Z” window by clicking the “OK”
button.
Clicking this icon will open the following window:
