2/7
Customer Support: www.TygerAuto.com/Contact
Move to the Passenger/Right wheel opening. Remove the
hardware attaching the plastic cover to the back and bottom of
the outer end of the front bumper, (Figs 1 & 2). Next, remove the
plastic clip attaching the cover to the side of the frame and
remove the cover, (Fig 3).
STEP 1
Repeat
STEP 1
to remove the plastic covers from the Driver/Left
side of the vehicle.
STEP 2
On models with factory fog lights and/or bumper mounted
sensors, unplug the harness leading to the front bumper, (Fig 4).
NOTE:
Fog lights and sensors will not be reinstalled.
STEP 3
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID
POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
INSTALLATION IS NOT COMPATIBLE WITH LASER CONTROLLED
CRUISE CONTROL SYSTEMS.
WARNING!
Do not crawl under bumper unless the bumper is
properly supported on blocks or stands or the bumper may fall.
(Fig 1) Remove hardware attaching plastic
cover to back of bumper (arrows)
(Fig 4) Disconnect fog lights and move
wiring harness away from bumper (arrow)
(Fig 2) Remove hardware attaching plastic
cover to bottom of bumper (arrows)
(Fig 3) Remove clip attaching plastic
cover to side of frame (arrow)
