Water Hose Installation
Water Hose Installation
18
19
Water Hose Installation
Water Hose Installation
ater Hose Installation
W
※
INTRO Screen appears in about 10 seconds
when initial power is supplied.
1. Place the unit on the planned installation location and
screw the flexible tube clockwise into the water outlet
hole positioned at the top of the unit. Do not over
tighten.
5. Make sure all hose connections are firmly seated in
the correct holes, both on the unit and at the water
supply
6. Turn on both the cold and hot water supply. Make
sure there are no leaks at any of the connections.
Make sure the faucet is working with both hot and
cold water. Make sure there are no leaks from the
hose connections on the bottom of the unit. Make
sure the hoses are firmly seated in the unit holes.
7. Plug in the power cord. You should hear a series of
tones when you power up the unit.
2.
3. Measure between the unit’s location (on the counter)
and the water faucet (or under-sink T-connection)
where the diverter (or T-connection) will be installed.
Cut enough hose to allow an easy connection from
the rear of the unit to the water supply (either using
the faucet diverter or the under-sink T-connection).
Note:
Keep the length from the unit to the faucet
under 16 feet (5 meters). You may need a pressure
pump or a larger size hose if the pressure is too low.
Be sure to leave a few extra inches (centimeters) of
length so the faucet can still be rotated.
Inflow
Drain
Inflow
4.
Connect the hose from the inflow hole to the cold
water supply either at the faucet diverter using Option
A, or the under-sink T-connection using Option B.
Option A:
Remove the nut from the diverter, slide the
nut onto the hose, then firmly seat the hose on the faucet
diverter and screw the nut over the hose and back onto
the faucet diverter.
Option B:
Route the hose through the countertop to the
T-connection, then firmly seat the hose on the T-connection
and make sure the connection is sealed completely.
hose to faucet
Press the stem elbows into the water inflow and
outflow holes on the bottom of the unit until you hear
a click and feel the hose sit firmly in place.
①
②
③
How to Install the Drain Faucet
Connect the drain hose tube elbow to the outflow hole
located at the bottom of the unit.
Connect the drain hose to the tube suction cup and
secure it so that it does not move.
Connect the drain hose to the faucet and secure it to
the proper position on the sink.