Tycon Power Systems Wireless EZ-Bridge LT2 Series, Initial Set-Up Procedure And Checklist

Page: 3 / 4

Tycon Systems

14641 S 800 W

Bluffdale UT 84065

tyconsystems.com Page 3
Step two continued:
O Using a different PC ( the WiFi feature disabled ) connect a CAT5/6 jumper cable
from the “ LAN ” port of the Injector to the Data port of your PC as shown below.
POE LAN
Data Port
O Arrange the Antennas within the same room so there is at least
an 8 foot separation as shown below.
8 ft. Separation
Antenna “ A ”
Antenna “ B ”
Router or Switch
Internet Source
PC
O From the “ B ” Side PC, try to access a known web - site via the Internet.
O If able to access the Internet, then the Antenna System is functioning properly.
O Go to page 4 and follow the shut - down procedure.
O If unable to access the Internet, please contact Technical Support for assistance.
support@tyconsystems.com