Tycon Power Systems Wireless EZ-Bridge LT2 Series, Initial Set-Up Procedure And Checklist

Page: 2 / 4

Tycon Systems

14641 S 800 W

Bluffdale UT 84065

tyconsystems.com Page 2
Antenna “ A ”
PoE Injector
Router or Switch
PC
Internet Source
O With your PC Powered on, plug the Injector into a constant 110 VAC power outlet.
— The Antenna should begin the boot - up process (Initialization).
— You should see the green LED illuminate to indicate power is present.
— You should hear two short beeps when the Antenna has completed a proper initialization.
O If proper Initialization happened, leave this configuration as is and in a powered - on state.
O If Initialization did not happen properly, please contact Technical Support for assistance.
Support@tyconsystems.com
CAT5/6
Jumper
Green
Power “ On ” LED
Step Two: Antenna “ B ” Initialization
— With the PoE wall–pack Injector unplugged from the wall outlet —
O Remove the bottom cover to access the connection points.
O Insert one end of a CAT5/6 jumper cable into the center port of the antenna
and the other end into the “ PoE ” port of the injector as shown below.
CAT5/6
Jumper
O Plug the Injector into a constant 110 VAC wall outlet.
— The Antenna should begin the boot - up process (initialization).
— You should see the green LED illuminate to indicate power is present.
— You should hear two short beeps when the Antenna has completed a proper initialization.
O If proper Initialization happened, go to page 3 for next steps.
O If Initialization did not happen properly, please contact Technical Support for assistance.
Support@tyconsystems.com
Green
Power “ On ” LED
No Connection to the “ LAN ” port
at this time.