2
Qwik Install
STEP 1:
Add Grounding Wire
Between Door and Enclosure:
Remove plastic covers on cop-
per studs on inside of door and
inside of enclosure. Add jumper
wire between 2 copper studs and
use copper washers and nuts to
secure.
STEP 2:
Add wire feedthrus into the bottom connector plate. Attach the
connector plate to the bottom of the enclosure using self tapping screws
provided.
STEP 3:
Install hole plug in drain hole in bottom right corner of the en-
closure.
STEP 4:
Mount the DIN rail to the door using screws provided. Mount
any extra equipment to the orange backplate and secure the backplate
in the enclosure. Note: The DIN rail can also be mounted to the orange
backplate if desired.
STEP 5:
If pole mounting the
enclosure, assemble the pole
mount kit to the back of the enclo-
sure and mount the enclosure to
a pole using the 6 hose clamps
provided. The enclosure can also
be wall mounted using the 4
holes in the back of the enclo-
sure.
