Tyco Puritan Bennett GoodKnight 425, Patient Manual

Page: 13 / 34

Revision C
GoodKnight 425 / GoodKnight 425ST Patient Manual 7
INSTALLATION
This chapter shows you how to connect the different accessories and cables to your device. Before
starting the installation, please check your device and its accessories by referring to the section titled
“Checking the Components” on page 3.
CAUTION
Place the device on a stable surface. Avoid placing it too near a wall or any other obstacle which
could obstruct the intake of air into the machine.
Standard Installation
1. Connect the breathing circuit to the device. To do this, connect the pressure tube to the pressure
port (Figure 3, item 5 on page 5). Connect the breathing circuit to the outlet connector of the
device (Figure 3, item 6 on page 5).
Figure 5 – Breathing Circuit Connection
WARNING
Take care that the pressure tube is not kinked or blocked.
2. Prepare the interface as described in its instructions for use.
3. Connect the interface (mask) to the breathing circuit’s free end.
4. Connect the power supply module cable to the supply connector located on the back of the device
(Figure 4, item 8 on page 5).
CAUTION
Use only the specific power supply module provided with the device.
5. Connect the power supply module plug to the mains. The device type is displayed temporarily,
then the following standby screen appears that shows the time:
10:29
Ÿ
6. The device is ready to operate. Proceed to the chapter titled “Using the GoodKnight 425” on page
12.
Breathing
circuit
Pressure tube
The colon is flashing