12
Network Activity LEDs (Red and Green)
(TL260GS-RS only)
Ethernet Activity:
Red LED will blink quickly once for Ethernet Transmit, or twice for Ethernet Receive.
GPRS Activity:
Green LED 2 will blink quickly once for GPRS Transmit, or twice for GPRS Receive.
Network Link LED (Yellow)
(TL260-RS only) See Figure 3.
The TL260-RS uses an additional Link LED on the board. LED is lit to indicate an active Ethernet connection.
.
Factory Defaults Reset
You can reset the programming options for the Communicator to the factory settings by installing the hardware
jumper. Perform the following steps to reset the Communicator:
NOTE: A jumper is required on AUDIO/DEFAULT pins 4 and 5 to reset the hardware values.
1. Remove panel front cover.
2. Locate the AUDIO/DEFAULT 5 pin connector in the middle of the Communicator board. On the PC1616/1832/1864 pan-
els pins 4 and 5 are on top. (See
).
3. Apply a jumper to short the hardware default pins 4 and 5.
4. Remove all power from the panel and then reapply power to the panel. Wait until the two green LEDs on the
Communicator begin flashing rapidly.
5. Remove the jumper from the hardware default pins 4 and 5. (Green LEDs will stop flashing).
NOTE: Your Communicator has now been reset to the factory default values.
Firmware Update
The firmware of the device can be updated over GPRS or Ethernet (Remote or Local updating):
• When the firmware update begins, all LEDs are ON.
• During the firmware update process, the LEDs will be cycled individually in a chaser pattern.
• After a successful update, the unit will automatically restart.
• Should the update fail, all 4 LEDs will flash ON, then OFF together at 1 second intervals.
NOTE: If the firmware update fails, restart the unit. For persistent update failures, contact your dealer.
COMMUNICATOR RESET / UPDATE
