Tyco Electronics M/A-COM P7100IP Series, Operator'S Manual

Page: 31 / 64

MM101332V1, Rev. K
If system selection is programmed to the SYSTEM/GROUP/CHANNEL knob, direct
access to systems will not be available. Pressing

or

will scroll through
different sets of 16 systems each (banks) if more than 16 systems are programmed into
the radio. The systems within each bank are then selectable via the
SYSTEM/GROUP/CHANNEL knob as described previously in METHOD 1.
Example:
System: 1 = North Group: 1 = Group 1
2 = South 2 = Group 2
3 = East 3 = Group 3
4 = West 4 = Group 4
Press

. (South is the currently selected system.)
Press

. (Press 4 to select “West” system.)
Press

. (West is the newly selected system.)
10.3 GROUP/CHANNEL SELECTION
Several methods can be used to select a new group or channel.
METHOD 1: From the control knob: If group selection is programmed to the
SYSTEM/GROUP/ CHANNEL knob, select a group by turning the
SYSTEM/GROUP/CHANNEL knob to the desired group number position.
The display registers the new group name on line two. If the knob is moved to
a position greater than the number of programmed groups, the highest
programmed group will remain selected. The Option 1 button can be
programmed to provide access to a “2
nd
bank” of 16 group number positions
(17-32)
METHOD 2: (System and Scan model radios only) From keypad: If group selection is
programmed as the primary function of

and

select a group by pressing

or

to scroll through the group list. The display registers the new group
name on line two.
METHOD 3:
(System model radios only) Direct Access: Press

to enter the group select
mode. Press the numeric key mapped to the desired group. Press

.
The radio
will move to the selected group.
METHOD 4: (Select model radios only) If programmed for groups, press the Option 1
button to change groups. The display registers the new group name on line
two. If programmed for channels, press the Option 1 button to change the
channel. The display registers the new channel.
31