Tomcat i875P S5102
Chapter 1: Introduction
1-1
http://www.tyan.com
Chapter 1: Introduction
1.1 – Congratulations!
You have purchased one of the most powerful solutions for the Intel Pentium
4 processor, the
Tomcat i875P S5102 Based on Intel 875P chipset, this platform offers convenient remote
Intelligent Platform Management Interface (IPMI) monitoring through a Server Management
Daughter Card. The Tomcat i875P S5102 are ATX form factor, onboard Gigabit Ethernet port,
Fast Ethernet port, Serial ATA, IDE RAID and an onboard ATI 8MB PCI RAGE XL VGA.
Remember to visit TYAN’s Website at
http://www.tyan.com
. There you can find information on
all of TYAN’s products with FAQs, distributors list, and BIOS setting explanations.
1.2 – Hardware Specifications
Processors
• Socket 478 processor
• Supports single Intel Pentium
4 processor
“Northwood / Prescott”
• Onboard VRM10
• Front-Side Bus support for 800/533/400MHz
Chipset
• Intel 875P North Bridge chipset
• Intel ICH5 South Bridge chipset
• Winbond W83627HF LPC I/O chip
• Analog devices ADM1027* hardware
monitoring chip
*NOTE:
ADM1027 chip may be available on
some Tomcat i875P models. Check the Tyan
website for updates: http://www.tyan.com
Memory
• Four 184-pin DIMM sockets
• Supports DDR 400/333/266
• Up to 4GB of Un-buffered ECC and non-
ECC type memory modules
• Registered Memory is NOT supported
Expansion Slots
• Four 32-bit / 33MHz PCI 2.3 slots
Integrated LAN Controller(s) (Optional)
• Two Gigabit LAN controller
Intel 82547EI Gigabit Ethernet controller
- Operating at 266MB/s CSA interface
Intel 82541EI Gigabit Ethernet controller
(Optional)
• One 10/100 Mbps LAN controller
Intel 82562ET 10/100 Mbps LAN controller
Intelligent PCI Graphic
• ATI Rage XL PCI controller
• 8MB Frame Buffer
Integrated PCI IDE (ICH5)
• Dual channel master mode support up
to four IDE devices
• Support for ATA-100 / 66/ 33 IDE drives
and ATAPI compliant devices
Integrated Serial ATA RAID
• Promise PDC20378 SATA RAID
controller
• Two Serial ATA RAID ports and one
Ultra ATA/133 IDE RAID port
• Support up to two SATA and two
ATA-133/100 IDE drives
• Supports IDE RAID 0, 1, 0+1(Need to
install two SATA Hard drivers and two
ATA-133/100 IDE drives
simultaneously)
System Management
• Total of three 3-pin headers
• Three fan headers with tachometer
monitoring
• Watchdog timer
Integrated I/O Interface
• One floppy connector supports up to
two drives
• Eight USB 2.0 ports (two rear
connectors and six ports by headers)
• Two 9-pin serial port (one rear
connector and one header)
• One 25-pin ECP/EPP/SPP parallel port
header
• One IrDA connector (via optional cable)
• Power/IDE LED connectors
