TYAN TN71-BP012, Service Manual

Page: 104 / 128

http://www.tyan.com
104
Progress Code Description
ISTEP 10.14 Perform any Cen scom inits
IStep 11 – DMI Training
ISTEP 11.01 Read out ECID off all Centaurs
ISTEP 11.02 DMI attribute update
ISTEP 11.03 DMI Scom setup on P8 MCS
ISTEP 11.04 Scom setup on centaur
ISTEP 11.05 Restore EDI Bus eRepair data
ISTEP 11.06 Calibrate DMI interfaces
ISTEP 11.07 Advanced pre DMI training
ISTEP 11.08 Run training on MC buses
ISTEP 11.09 Advanced post DMI training
ISTEP 11.10 Initialize EDI Frame
ISTEP 11.11 Load PRD for DMI domain
ISTEP 11.12 Start listening for attentions
ISTEP 11.13 Set the Inband base addresses
IStep 12 – MC Config
ISTEP 12.01 Collect Master DIMM SPD
ISTEP 12.02 Calculate DIMM voltage
ISTEP 12.03 Calculate DIMM frequency
ISTEP 12.04 Determine effective config
ISTEP 12.05 MSS attribute update
IStep 13 – DRAM Training
ISTEP 13.01 Disable VDDR on CanContinue loops
ISTEP 13.02 PLL Initfile for MBAs
ISTEP 13.03 Setup PLL for MBAs
ISTEP 13.04 Start clocks on MBAs
ISTEP 13.05 Enable the VDDR3 Voltage Rail
ISTEP 13.06 Perform scom inits to MC and PHY
ISTEP 13.07 Soft reset of DDR PHY macros
ISTEP 13.08 DRAM initialize
ISTEP 13.09 DRAM training
ISTEP 13.10 Advanced DRAM training
ISTEP 13.11 Hand off control to MC
ISTEP 13.12 Pass in all DIMMs on a given power domain
IStep 14 – DRAM Initialization
ISTEP 14.01 Load PRD for DRAM domain