TYAN S8032, Manual

Page: 19 / 161

http://www.tyan.com
19
J120: BUZZER_SEL Jumper
Signal Pin Pin Signal
VCC5_BZ 1 2 NG
BUZ_1 3 4 BUZ_2
3-4: NORMAL MODE (Default)
2-3: Disable PC BEEP
1-4: Use the External Speaker
J192: System Reset Jumper
Signal Pin Pin Signal
COLD_RST_BTN_N 1 2 FP_RST_BTN_JP_N
BMC_EXTRST_BTN_L 3
1-2: SYSTEM RESET (Default)
2-3: BMC RESET
J200:FPIO_PW_SEL (33_DUAL/RUN)
Signal Pin Pin Signal
FPIO_PW_LED_33_DUAL 1 2 FP_PW_LED_PW
FPIO_PW_LED_33_RUN 3
1-2 VDD_33_DUAL
2-3 VDD_33_RUN
J194: CMOS Clear Jumper
Normal
( Default )
Pin 1 2 3
Signal Vbat P0_Vddbt_Rtc_G GND
1-2 Normal RTC Reset (DEFAULT)
2-3 Clear RTC Registers
You can reset the CMOS settings by using this jumper. This can be
useful if you have forgotten your system/setup password, or need to
clear the system BIOS setting.
1. Power off system and disconnect power connectors from the
motherboard.
2. Remove the jumper from Pin_1 and Pin_2 (Default setting).
3. Move the jumper cap to close Pin_2 and Pin_3 for several seconds
to Clear CMOS.
4. Put jumper cap back to Pin_1 and Pin_2 (Default setting).
5. Reconnect power connectors to the motherboard and power on
system.
Clear CMOS