TYAN S5539, User Manual

Page: 50 / 108

http://www.tyan.com
50
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow devices
may require more than 1 stop bit.
1 / 2
Flow Control
Flow Control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a „stop‟ signal can be sent to stop the data flow. Once the
buffers are empty, a „start‟ signal can be sent to restart the flow. Hardware flow
control uses two wires to send start/stop signal.
None / Hardware RTS/CTS
VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Enabled / Disabled
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Disabled / Enabled
Resolution 100x31
Enable or disable extended terminal resolution.
Disabled / Enabled
Legacy OS Redirection Resolution
On Legacy OS, the number of rows and columns supported redirection.
80x24 / 80x25
Putty KeyPad
Select FunctionKey and KeyPad on Putty.
VT100 / LINUX / XTERMR6 / SCO / ESCN / VT400
Redirection After BIOS POST
The settings specify if bootloader is selected than Legacy console redirection is
disabled before booting to Legacy OS. Default value is always enable means
Legacy.
Always Enable / Bootloader