http://www.tyan.com
90
4. Press Enter. The RAID Config screen appears.
5. From the RAID Config screen, enable RAID, then enable any of the disks
that you want to use as RAID disks. In the figure above, the master and slave
drives on the secondary IDE port are enabled as RAID disks. Make sure to
enable the SATA drives also if you are setting up a RAID 0+1 arrary.
6. Press
F10
to save the configuration and exit. The PC reboots.
7. Enter the RAID BIOS setup by pressing
F10
when prompted, and proceed
to set up NVIDIA RAID BIOS as described in the next section.
Summary of Contents for S3892
