http://www.tyan.com
34
4
1
8
5
EPS 12V 8-pin (CPU Power)
4 GND 8
+12V3
3 GND 7
+12V3
2 GND 6
+12V3
1 GND 5
+12V3
Applying power to the board
1. Connect the EPS 12V 8-pin power connector.
2. Connect the EPS 12V 24-pin power connector.
3. Connect power cable to power supply and power outlet
NOTE
YOU MUST
unplug the power supply from the wall outlet before
plugging the power cables to motherboard connectors.
2.14 – Finishing Up
Congratulations! You’re finished setting up the hardware aspect of your
computer. Before closing up your chassis, make sure that all cables and
wires are connected properly, especially IDE cables and jumpers. You may
have difficulty powering on your system if the motherboard jumpers are not
set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by
calling your vendor’s support line.
