http://www.TYAN.com
32
2.34 – Installing the Power Supply
There are three power connectors on your Tiger K8W S2875. By default, the Tiger K8W
S2875 requires that you have an EPS12V power supply that has a 24-pin and an 8-pin
power connector. However, the Tiger K8W S2875 is also ATX12V compatible. All 3 power
connectors need to be used if you plan on using the ATX12V power.
Power Supply
Main
power connector
12V
power connector
4-pin AUX
power connector
EPS12V
Required
Required
Not required
ATX12V
Required
Required
Required
Disconnect power supply from electrical outlet
1. Connect 12V power connector
2. Connect 4-pin AUX power connector (required for ATX12V power)
3. Connect Main power connector
4. Connect power cable to power supply to power outlet
NOTE
YOU MUST
unplug the power supply before plugging the power cables to
motherboard connectors.
2.35 – Finishing Up
Congratulations on making it this far! You’re finished setting up the hardware aspect
of your computer. Before closing up your chassis, make sure that all cables and wires
are connected properly, especially IDE cables and most importantly, jumpers. You
may have difficulty powering on your system if the motherboard jumpers are not set
correctly.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please find
setup information and documentation online at our website or by
calling your
vendor’s support line.
