http://www.tyan.com
35
2.14 - Installing the Power Supply
There are two power connectors on your Tomcat K8E S2865. The Tomcat K8E
S2865 requires that you have an EPS12V power supply that has a 24-pin and
an 8-pin power connector. The Tomcat K8E also supports ATX 2.x and ATX12V
power supplies (20-pin + 4-pin). Please be aware that the 1
st
pin of 20-pin power
connector should be align with the 1
st
pin of 24-pin power connector on the
motherboard.
Applying power to the board
1. Connect the EPS 12V 8-pin power connector.
2. Connect the EPS 12V 24-pin power connector.
3. Connect power cable to power supply and power outlet
NOTE
YOU MUST
unplug the power supply before plugging the power cables
to motherboard connectors.
2.15 – Finishing Up
Congratulations on making it this far! You’re finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by
calling your vendor’s support line.
