http://www.tyan.com
34
(continued from previous page)
3.6 Power Management Setup
This section describes the different power management functions that may be available on your system.
Please note that power management functions are also dependent on your OS’ power management func-
tions, and that both OS and system power management functions should be set up to work in conjunction
with one another.
(continued on next page)
Onboard Parallel Mode
Onboard Parallel Port
Sets logical LPT port address and corresponding interrupt.
[Default setting is
378/IRQ7
]
ECP Mode Use DMA
Sets mode for onboard parallel port. [Default setting is
Normal
]
Sets whether parallel port should use DMA for faster transfer
rate. [Default is
3
]
Parallel Port EPP Type
Sets parallel port data transfer mode. [Default is
EPP1.9
]
Power Management (subscreen)
ACPI Function
Enable or Disable Advanced Configuration Power Interface.
[Default setting is
Enabled
]
Power Management
Lets you enter the screen for configuring power states.
Sets whether each mode should be set separately. [Default is
User Define
]
HDD Power Down
Sets time that system should wait before powering down the
HDD(s). [Default is
Disable
]
Doze Mode
Suspend Mode
Sets time that system should wait before CPU clock runs at
slower speed to save power. [Default is
Disabled
]
Sets time that system should wait before suspending all devices
except for CPU, to save power. [Default is
Disabled
]
Sets type of suspend function to enable once the system enters
suspend mode. [Default is
S1(POS)
]
Sets power-saving mode for video display. [Default is
Suspend-
>Off
]
ACPI Suspend Type
Video Off Option
Reserved. [Default is
Yes
]
PM Control by APM
Determines manner in which the monitor is blanked. [Default is
V/H SYNC+Blank
]
Video Off Method
If Modem Ring Resume is Enabled, it’s possible to wake the
system up by dialing into it. [Default is
3
]
Modem Use IRQ
