http://www.tyan.com
14
2.6-P. CPU Frequency Settings (JP7, JP8, JP9, JP10)**
NOTE: The following settings are only valid if a non-retail/engineering sample CPU is installed. On retail
CPUs, settings will automatically be detected and used accordingly.
2.6-Q. Soft Power Connector
The soft power connector is part of jumper block J12 (pins 6 to 8). This board uses the chipset for power
management, including turning on and off the system. If the power button function option in the BIOS
Power Management menu is set to “On/Off” (which is the default), pressing the power button once after
the BIOS has booted up will turn the system on and off. If the power button function is set to Suspend,
pressing the power button once will wake up the system or send it to Suspend mode. In this case, you
cannot turn the system off unless you shut down through the Windows operating system or you hold the
power button down for four seconds.
2.6-R. Hardware Reset Switch Connector Installation
The reset switch on your chassis case provides you with the Hardware Reset function, which is the same
as power on/off, except that the system will immediately execute a cold start after the reset button is
pushed.
2.6-S. Flash Utility
You can upgrade the BIOS of this motherboard by using the Flash Utility (see
p. 38
). Check the Tyan
website for details:
http://www.tyan.com
* check the Tyan website for updates:
http://www.tyan.com
2
3
4
5
ON
5.5
Ratio
CPU
Speed
JP7
JP8
JP9
JP10
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
7.5
9.5
11.5
OFF
OFF
OFF
OFF
300
433
Bus
Speed
100
133
100
133
100
133
100
133
100
133
100
133
100
133
100
133
66
400
533
333
500
667
200
333
550
733
66
66
66
66
366
500
750
997
633
950
1264
733
1150
1530
OFF
ON
ON
ON
ON
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
** under qualification at time of printing, check the Tyan website for updates:
http://www.tyan.com
