Twyford X52 Series, Instruction Booklet, Page: 10 / 16

10
Deck Mounted Bath Filler and Bath Shower Mixer
Identify all components are present prior to starting
the installation.
1. Fit the mixer body to the bath ensuring that the
gasket is between the body and bath.
2. Secure the mixer to the bath using the washers
and plastic backnuts below the bath.
Tighten the backnuts onto the threaded tails.
A suitable spanner may be required to fully
tighten the backnut.
3. Connect the hot and cold water supplies to the
threaded tails using a ¾” BSP connector or
preferably an isolation valve for future servicing
convenience (not supplied).
4. Bath Shower Mixer only - fit the shower hose to
the hose outlet using the small sealing washer,
and the handset to the hose using the small
washer.
5. Fit the wall bracket (not shown) to the wall using
the fixings supplied, ensuring the handset and
hose reaches it.
6. To switch from bath to shower mode, pull the
diverter knob up, to revert back to bath filling
mode push the diverter knob back down.
7. Turn on water supplies and turn both handles int o
the on position, letting the water flow for a few
minutes and purging all air.
8. Check all joints and connections for any leaks.
Installation continued
(X525255CP, X525265CP)
Prior the drilling into walls, check there no
hidden electrical wires, cables or water supply pipes
with the aid of an electronic detector.
If you use power tools do not forget to:
• Wear eye protection
• Unplug equipment after use
Drawings for illustration purposes only
Washer
Backnut
Shower hose screws in
from underneath.
Gasket
Diverter knob