5
step 10.
Fit the profile cover caps as shown. Then apply the badge as indicated.
step 11.
Adjust the door by slackening the hing block screws top and bottom. The
glass door should be square in the frame and operate smoothly. If the door
fails to shut positively make sure the polarity of the magnets are correct.
step 12.
Install handles as per diagram.
step 13.
Using good quality clear silicon sealant, seal the enclusure to the wall and
tray along the following joints:
A
: Outside vertical enclosure-to-wall joint.
B:
Inside vertical enclosure-to-well joint.
C
: Outside Perimeter enclosure-to-tray joint.
D
: 150mm high wall profile-to-enclosure joint.
(Make sure side panel is sealed in the same
way, if installed.)
step 14.
Installation in a corner.
Position left and right wall profiles as shown in the diagram.
Once complete, continue with steps 2-5.
pivot_ST0210_A4.indd 5
10.02.2010 10:00:10
