3
step 1.
Installation in an alcove.
Position the wall profiles approx 8mm in from the edge of the tray or inside
of up-stand.
For installation with a side panel please see step 14.
step 2.
Make sure both wall profiles are upright using a spirit level.
step 3.
Mark the position on the wall through the pre drilled holes with your pencil.
Carefully move the wall profile away from the wall and put somewhere
safely to avoid damage when you start drilling.
step 4.
Drill holes where marked using the 6mm masonry drill bit. (You may need a
specialized drill bit if you are drilling into tiles, if unsure please get advice).
You can now install the wall plugs that have been provided.
!
Prior to installation:
Before Installing the shower screen, install the shower tray as per the
manufacturers instructions making sure that tray is level in all directions.
pivot_ST0210_A4.indd 3
10.02.2010 10:00:08
