TWR Lighting E-1DB2, Manual

Page: 8 / 49

M.E-2009.E-1DB2
3/25/07 – rev. 5/28/09
E-1DB2 CONTROLLER
WARNING DANGER!!!
THIS SYSTEM OPERATES AT HIGH VOLTAGE LEVELS THAT COULD BE
LETHAL TO SERVICE PERSONNEL. ALL INSTALLATION AND MAINTENANCE
WORK SHOULD BE DONE BY QUALIFIED SERVICE PERSONNEL ONLY.
WHEN PERSONNEL IS INSTALLING SYSTEM OR PERFORMING
MAINTENANCE ON THIS SYSTEM, MAKE SURE THE POWER IS TURNED OFF
AT THE SERVICE BREAKER PANEL!!
READ AND UNDERSTAND THE THEORY OF OPERATION AND ITS SAFETY
MESSAGES BEFORE ATTEMPTING INSTALLATION/MAINTENANCE OF THIS
SYSTEM. DO NOT ATTEMPT TO DEFEAT THE INTERNAL SAFETY SWITCHES
IN THE CONTROLLER AND BEACON!!
2.5.1 Beacon Mounting and Wiring (Refer to Drawings HD0-329, and INS-329)
2.5.1.1 Bolt the beacon to the mounting plate using four (4) 5/8" X 1 1/4"
galvanized bolts that are supplied. Installer should make sure to
check for full thread engagement on Anco locknut. Allow 16"
clearance in back of the hinge (25" from the center of the base) to
tilt lens back without hitting an obstruction.
2.5.1.2 Level the beacon using the spirit level at the base of the lens.
Shims may be used under beacon base or triple nutting each bolt
with palnuts on all four (4) nuts.
2.5.1.3
Slip the electrical cable for the dual beacon through the watertight
connector (cable gland bushing), and tighten the gland nut to
make a watertight seal. Attach the wires to the terminal strip as
follows:
Connect Cable To Lamp platform Terminal
Wire Color Match Wire Color Block Number
10 Gauge Red/Black 12 Gauge Red/Black 2
10 Gauge Red 12 Gauge Red 3
14 Gauge Green 16 Gauge Green 4
10 Gauge Black 16 Gauge Black 5
14 Gauge White 16 Gauge White 6
14 Gauge White/Green 16 Gauge White/Green 7
16 Gauge Blue 16 Gauge Blue 8
16 Gauge Brown 16 Gauge Brown 9
16 Gauge Bare Wire Beacon Base
4