Reach In Refrigerator User Manual
Ensure that, in respect of the dimensions (fig.2), the space reserved for
The equipment permits its correct utilization and ease of maintenance.
After carefully unpacking the display case, remove the white PVC
protective film and all of the manufacturer’s material which safeguards
The item in transit.
Place the cabinet on a flat surface and level it by screwing and adjusting
The leveling legs to ensure its efficient operation (fig.3).
The cabinet must be lifted only from the exterior of the base to avoid the
Possibility of damage, and in the case of utilizing mechanical means, position the forks as indicated
on fig.1.
If the device has been positioned horizontally (integral condensing unit),
Wait two hours before activating it. Control the content of the unit before
Closing it with the key, and make sure to keep the keys out of the reach
Of small children, far from the apparatus.
Packing and protective film should be disposed off as indicated by the local authorities.
The equipment must not be installed within explosive ambience, in the open air or exposed to rain,
the correct sitting is: distant from heat sources (radiators, direct lighting, etc.) and protected from
direct sunlight and draughts. Air circulation must be freely maintained around the condensing unit,
be it integral or remote (fig.4).Inobservance of these specific conditions will detrimentally affect the
cabinet.
4.2 Initial cleaning
Before use, all parts of the cabinet should be cleaned. For the walls and all the internal parts use and
antibacterial detergent. For the plastic parts use a moistened cloth. Dry with a soft clean cloth. Use
little or no water. Do not use harsh or abrasive solvents or detergents. During cleaning do not
approach bare-handed those parts which could cut (evaporator, condenser, etc.) and always use
protective gloves.
4.3 Positioning of components and accessories
4.3.1 Gastronorm cases (fig.5)
All the accessories that can replace the grills are insertable into the same wall supports that the
grills use. Position the grill supports inside the cell with the spacing most suitable for the intended
use, inserting each support into the attached bored posts in the back of the cell and then placing the
protruding lateral tongue into the appropriate slot located on the side posts of unit. Slide the grills
into the attached supports. In the double door units the central grills, placed above the two lateral
supports, can be removed or replaced above the supports in a new position if so desired.
4.3.2 Base cases (fig.6)
Position the basin which collects the condensed water in the appropriate guides located underneath
the unit. Screw down the door handle and reposition the screw cap covers. Place the grills onto the
slots of the plastic posts attached to the inside walls.
4.4 Electrical connection (fig.7)
Check that the supply conforms to the requirements listed on the factory label and that it is
provided with a fail-safe protection or automatic circuit breaker with an efficient earth connection.
Should there not be an electrical safety feature, have this introduced by a qualified person, by means
of a omnipolar switch as indicated in the safety regulations with a minimum clearance of the
6
NO.18 - 105, HUAGANG GARDEN, ZHONGSHAN AVENUE, GUANGZHOU, CHINA
T: 86-20-38768241 | F: 86-20-38769376 |
