background image

4

WARNING

•  Reduced battery autonomy in winter is perfectly normal since the battery performance decreases in cold 

weather.

•  Store the product with the charged battery. Leaving the product with discharged battery or with battery level 

close to 0% over long periods of time may cause damage to the battery. Recharge the device at least once 
a month even if you did not use it.

•  Keep the device in a sheltered, cool and dry place. Wet places may cause condensation inside the battery 

and damage it.

•  Recharge the battery in a clean, dry place, away from inflammable objects, heat sources and direct sunlight.
•  Do not overcharge the batteries.
•  Do not recharge at temperatures close to 0°C.
•  Use the provided power supply only.
•  Do not use the device while it is charging.

TURNING YOUR SCOOTER ON AND OFF

To turn Onekick Two on and off push the central button on the display for a few seconds. The display will light up 
to confirm that the scooter has been turned on.
Onekick Two is equipped with an LED light on the front. You can also turn the LED light on and off by means of the 
dedicated button on the handlebar.

SELECT SPEED

Onekick Two has three speed levels, which you can select by pressing the upper or lower button on the display 
one or several times.
Press the upper button to increase speed from level 1 to level 3. Level 1 indicates low speed, level 2 indicates 
intermediate speed and level 3 indicates high speed.
Press the lower button on the display to decrease the level of speed.
It is advisable to move gradually, starting from low speed and gradually increasing the speed to the other two 
levels only after you have become well acquainted with the device.

CHANGE THE DISPLAY MODE

Change the information on the display by pressing the ON/OFF switch to pass from one mode to the other:

DIS:

 distance covered

TIME:

 amount of time the device has been used

ODO:

 total distance covered

VOL: 

voltage during use

RPM: 

engine revolutions per minute

GUIDE

•  Hold the handlebar with both hands and place one foot on the platform.
•  Use the foot on the ground to push yourself forward and take off. Then push the accelerator lever on the 

handlebar. Once you reach a speed of 3 Km/h the engine will start.

•  Especially when you are still learning to use the vehicle, try to moderate your speed to become more familiar 

with the device.

•  To slow down, you can use either the electrical or the mechanical brake.
•  To use the electrical brake, you need to push down the lever on the left-hand side of the handlebar while 

driving and be careful not to push too hard and too abruptly to avoid blocking the wheel.

•  The mechanical brake is located on the rear wheel and can be activated by pushing on the wheel cover with 

your rear foot. The pressure will slow down the scooter.

Speed

Reviews: