Two Technologies TechTerm TT1R2, Technical Reference Manual

Page: 18 / 50

Operation 8
Connecting the Terminal
To connect the terminal to a host device using Two Technologies parts:
1. Plug one end of a 1210 modular cable into the modular connector on the bottom of
the terminal. Plug the other end into the PCAT adaptor .
2. Plug the PCAT adapter into the host device.
Power
Line-Powered Units
To supply power to a line-powered TechTerm:
1. Plug one end of a 1210 modular cable into the modular connector on the bottom of
the terminal. Plug the other end into the PCAT adaptor .
Figure 2-5: Cable Connections
Bottom of Unit
Modular Cable
PCAT Adapter
Power Supply/
Battery Charger
2. Using a Two Technologies’ power supply (such as a Two Technologies 1226-1 linear
power supply for units with a -2 power supply configuration), plug the power
supply connector into the PCAT adapter and then plug the power supply into a 120
VAC 60 Hz power outlet.
3. The terminal should turn on and a blinking cursor should appear on the display. If
the terminal does not turn on, refer to the
Troubleshooting section of this manual for
help.