20mm
50mm
50mm
30mm
30mm
20mm
Control Throws
C.G.
Elevator
Rudder
19
Ailerons
120 mm
Important Safety Precautions
4.8in.
P. 11
The ideal C.G. position is 120mm (4.8 in.) behind the leading edge
measured at where the wing meets the fuselage. In order to obtain
the C.G. specified, add weight to the fuselage or move the battery
position. Check the C.G. before flying.
Adjust the control throws as shown in
the diagram. These throws are good for
general flying. You can adjust according
to your personal preference.
Warning
!
# First time flyer should never fly by himself / herself. Assistance from experienced
flyer is absolutely necessary.
# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly
pre-adjusted aircraft.
#
is specially designed to be powered by
2C 0.60-0.75 or 4C 0.91
engine, using a more powerful engine does not mean better performance. In fact,
over powered engine may cause severe damage and injuries.
# Make sure the air field is spacious, never fly the plane too close to people and never
get too close to a running propeller.
# If you find wrinkles on the covering as a result of weather changes, you can use hot
iron to remove the wrinkles. Please begin with lower temperature setting and
gradually raise the temperature until the wrinkles are gone. Too hot an iron may
damage the covering. Don't use hot iron near the seams or edges, hot iron will
melt the glue and shrink the covering at the same time, causing the seams to pull away.
# Check and re-tighten up all factory assembled screws, use thread locker if necessary.
http://www.theworldmodels.com/para/instruction/instructionManuals.php
A156SPO25891108
Summary of Contents for EXTRA 330L 60
Page 15: ...A156SPO25891108...
