14
ID CODE
Assigning ID CODE to the remote control, enable distinguishing
between remote controls that are placed nearby.
When two or more remotes are placed near by there is a chance
that the I.R transmission from one remote will be received by the
wrong I.R receiver
Pressing simultaneously the MODE & ROOM button for more
than 6 seconds, while the remote control is On, will allow entering
the ID CODE setting of the remote. The LCD will show 00 blinking.
By pr / - the code is selected .The ID CODE range is
from 00 to 08. Pressing SET button will store the ID CODE and
the display is back to normal operation with the last temperature.
If the SET button is not used for over 6 sec from last button press,
the modification shall be canceled automatically and recover the
normal operation with the original ID code (the one used before
entry to the modify mode).
When replacing the batteries the E set again ID COD.!!!
BATTERIES LOW
When batteries are low, the LOW BAT icon will be shown. Replace the
old batteries with new AAA batteries (Alkaline).
Set clock as mentioned above.
