SET UP
1. Select a stable, level area for set up.
2. Unhook trailer and lights from tow vehicle and roll to set up area.
3. Carefully raise the unit into its upright position. Assistance will be required.
4. Remove the nut from the and unlock the safety chain from the support legs and swing them down so
that they are firmly resting on the ground. Then wrap the chain around the frame and lock. Stake the
unit down secularly. If it is not possible to stake down, then weight the unit down with 800lbs on
each side.
5. REVIEW SAFETY RULES!!
OPERATION
1. Check to see that the unit is on a firm and level surface.
2. Inspect the mallet to make sure that the head is securely attached to the handle.
3. Block off a “striking zone” with plenty of room for the participant to safely swing the mallet with no
danger of hitting a spectator or passer-by. Note: occasionally the mallet will bounce off the side of the
rubber pad, so make sure the spectators are kept clear of this area.
4. If the Easy Striker moves or “walks” during use, drive 4 stakes through the 4 holes on the sides of
the unit.
5. The level of difficulty can be adjusted by raising or lowering the spacer under
the back end of the high striker arm. Simply have someone push down on the
front of the arm, while you turn the spacer lever (counter-clockwise to raise or
clockwise to lower). Use the lower lever to lower the nut and tighten the spacer
in place.
TAKE DOWN
1. Raise the support legs and secure with the locking nut and wrap the safety change around the frame
to be certain the legs will not drop down while in tow.
2. Carefully lower the unit back onto its wheels. Assistance will be required.
3. Attach trailer to vehicle. Put pin or bolt through hitch release lever and secure. Attach safety chain
to vehicle.
4. Hook up lights to tow vehicle, and be sure to test the turn signals and brake lights before towing.
Summary of Contents for EASY STRIKER
Page 1: ......
