1. Remove all packing, and remove unit from pallet and crate. Lay frame on back so that the wheels
are on the ground. Place something solid (such as concrete blocks) under both the front and back edg-
es of the frame in order to support it and keep it parallel to the ground.
2. Block the wheels so that the unit will not roll or move during assembly.
3. Slide the tower into the frame until it is against the base of the frame and the bolt holes line up.
Attach the tower to the frame using the 1 1/2” bolts at the bottom of the frame and the 3” bolts at the
top of the frame.
4. If you have a Trailer Unit, attach the bell using the 7” bolt. If you have a Park Unit, attach the bell
using the 5” bolt. Put the bolt through the bell. Then slide a washer onto the bolt behind the bell.
Then slide the spacer onto the bolt, followed by another washer. Then put the bolt through the hole at
the top of the striker and put a washer onto the bolt along with a locking washer.
(#5 is for Trailer Deluxe units only.)
5. As you face the bottom of the Easy Striker place the tail-light marked “road side” on the left side
light bracket, and place the light marked “curb side” on the right side light bracket. Pull out enough
cable so that it will extend about two feet beyond the end of the trailer hitch. (This is to insure that
there will be enough slack for sharp turns.) Run the light cord along the bottom of the trailer frame
taping or tying it to the underside of the frame. Run the yellow/brown cord to the “road side” (left)
bracket and feed it through the hole in the bracket. Run the green/brown cord to the “curb
side” (right) bracket and feed it through the hole in that bracket. Cut of the excess cable on both sides
and strip about a 1/4” of insulation off the ends. Insert the ends of cable into their respective holes in
the back of the light units. (The white cable can be used for grounding purposes.) Using the nuts in-
cluded in the light kit attach lights to the brackets. (After the trailer is hooked up to a vehicle, be sure
to test the turn signals and brake lights before towing.)
Summary of Contents for EASY STRIKER
Page 1: ......
