Figure 6
REMOTE CONTROL FUNCTIONS
E-6
REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH CONTROL PANEL FUNCTIONS
3 BUTTONS REMOTE
23EF020GRA, 28EF020GRA & 33EF020GRA
MODELS ONLY
See Figure 6
POWER
HEATER
FLAME
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
FLAME
HEATER
POWER
ELECTRIC FIREPLACE REMOTE
NOTE:
The insert Main Power Switch must be switched
ON in order for the Remote Control to function.
The Power button will put the insert in a standby
mode. This will turn off all functions at once but
will hold the settings in memory. By pressing the
button again the unit will turn on at the same settings.
Each time the flame button is pressed, the intensity
of the flame decreases. There are six brightness
levels you can cycle through including the OFF setting.
This button will turn the power to the heater and
blower ON and OFF. The blower starts to work and
blow hot air when turn on this button. The rotary switch
(TEMPERATURE) controls the thermostat feature
to help regulate your room’s temperature accordingly.
NOTE: This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never dispose of
batteries in fire, except under conditions of controlled i
ncineration. (Failure to observe this precaution may
result in an explosion.)
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receive
r.
• Connect the equipment into an outlet on a circuit different f
rom that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications not approved by the party responsible for compliance could void user’s authority to
operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.