Twin Cut 08-00002/3, Instruction Manual

Page: 27 / 28

27
MOUNTING OF REPLACEMENT BLADES
See the accessories section of this manual for the proper replacement blades
that are needed for this saw.
1. Unplug the saw.
2. Lay the saw down with the blade arbor pointing upward. Open the lower
guard (Fig.4).
3. Place blade "A" onto the flange with the "A" clearly visible (see Fig.-3).
4. Align the holes on the blade with the pins on the flange and securely fit the
blade on the flange (see Fig.4).
5. Place the blade "B" onto the adaptor with the "B" easily visible, then thread
lock nut onto shaft. DO NOT tighten, (see Fig.6).
6. Turn the blades so that the holes in both blades are lined up.
7. Place the pin (included with the wrench) into the lined up holes.
8. Tighten the lock nut clockwise and then remove the pin from the blades
(see Fig.7). This will allow the blades to turn freely.
9. Carefully turn blades with your hand to be sure they easily turn in opposite
directions.